Customer Reviews - T connector Wiring Harness
[56040]

$72.42 $65.84

---

by William Bunchalk | Date Added: Friday, February 28, 2014

Product Rating

Excellent product, went in with no problem. you have to remove most of the back area, but instruction are detailed enough, and you won't have any trouble if you take your time and follow them.

---

by Lascom Robinson | Date Added: Thursday, May 13, 2010

Product Rating

WIRE TRAILER HARNESS:
2010 Subaru Outback.

Fit perfectly, was in and out in about 15 mins., tested ok on trailer. Ran end connector down through the rubber filler plug underneath spare tire, and out the bottom. Store it lodged between the hitch and the plastic bumper guard. Simply pull out some slack wire when you need it.

---

by Charles Stek | Date Added: Thursday, May 6, 2010

Product Rating

Good product, easy to install, reasonable price. Only problem was initially finding the Subaru wiring harness.

---

by David Dailey | Date Added: Tuesday, January 19, 2010

Product Rating

WIRE TRAILER HARNESS:
2010 Subaru Outback.

Carefully remove the syrofoam panels of the trunk, above the spare tire. The snap connectors are delicate.

Carefully reach up under the edge of the driver side 'felt' quarter panel lining.
right near the d-ring tie down, you will find a taped t-connector, Subaru installed for trailer lights.
Plug in, and run the wiring into the wheel well. There is a rubber plug, in the front of the wheel well (there are two others too), if you want to run the wires to the outside, hitch, or just leave it in the wheel well until you need to tow, then smash in into the trunk door, and run the wires outside directly.

Excellent product!!!

---

by Eugene Forsythe | Date Added: Thursday, September 10, 2009

Product Rating

The most into a factory pre-wired connection, cut a rubber body plug for wire to exit, couple of zip-ties and done. It took longer to get the spare tire out, than to install. Great

---