CALL TO

ORDER

  • FREE SHIPPING
  • LOW PRICE GUARANTEE
  • SAVE UP TO 40%

On All Orders Over $99

live chat
 

T connector Wiring Harness
[ 56040 ]

List Price: $52.02
Our Price: $30.01
Orders for Curt products over $99 qualify for Free Shipping!
 
5.0 Star Rating: Recommended  (5 customer reviews)

Manufacturer: Curt Manufacturing
Part Number: 56040

Need trailer wiring? These plug-and-go wiring harnesses are the way to go. They're specifically designed for your vehicle and do not require splicing into your vehicle's wiring. The harness is designed with the wiring, connectors, and circuitry needed to adapt your vehicle's electrical system for trailer compatibility. All wiring harnesses include detailed installation instructions.

This wiring harness is designed to fit the following vehicles:

2009-2015 Subaru Forester
--Fits Model(s): All
--3 wire system, powered converter included
2010-2015 Subaru Outback
--Fits Model(s): Except Sport
--3 wire system, powered converter
2013-2014 Subaru XV Crosstrek
--Fits Model(s): All
--3 wire system, powered converter included

Note: Because we do not have unique pictures of every wiring harness we carry, this wiring harness may vary slighty from the picture above.



Manufacturer: Curt Manufacturing
Part Number: 56040
Current Reviews: 5

Customer Reviews


William Bunchalk - 02/28/2014        Rating: 5 of 5 Stars!
Excellent product, went in with no problem. you have to remove most of the back area, but instruction are detailed enough, and you won't have any trouble if you take your time and follow them.
Lascom Robinson - 05/13/2010        Rating: 5 of 5 Stars!
WIRE TRAILER HARNESS:
2010 Subaru Outback.
Fit perfectly, was in and out in about 15 mins., tested ok on trailer. Ran end connector down through the rubber filler plug underneath spare tire, and out the bottom. Store it lodged between the hitch and the plastic bumper guard. Simply pull out some slack wire when you need it.
Charles Stek - 05/06/2010        Rating: 5 of 5 Stars!
Good product, easy to install, reasonable price. Only problem was initially finding the Subaru wiring harness.
David Dailey - 01/19/2010        Rating: 5 of 5 Stars!
WIRE TRAILER HARNESS:
2010 Subaru Outback.
Carefully remove the syrofoam panels of the trunk, above the spare tire. The snap connectors are delicate.
Carefully reach up under the edge of the driver side 'felt' quarter panel lining.
right near the d-ring tie down, you will find a taped t-connector, Subaru installed for trailer lights.
Plug in, and run the wiring into the wheel well. There is a rubber plug, in the front of the wheel well (there are two others too), if you want to run the wires to the outside, hitch, or just leave it in the wheel well until you need to tow, then smash in into the trunk door, and run the wires outside directly.
Excellent product!!!
Eugene Forsythe - 09/10/2009        Rating: 5 of 5 Stars!
The most into a factory pre-wired connection, cut a rubber body plug for wire to exit, couple of zip-ties and done. It took longer to get the spare tire out, than to install. Great
Write a Review
 

Related Products and Accessories