SMI Stay-IN-Play Duo Brake system
[9599006]

$1,913.81 $1,739.83

by Eddie Ray | Date Added: Friday, August 28, 2015

Product Rating

So we finished the install today. We had finished the Jeep install part a Month ago. All went smooth just slow on my part. Took our time and ran all wires in Convoluted Tubing. Install was pretty straight forward just followed the instruction.
I wanted the brake notification light on the dash of the MH. What I did was attached the light wire to the Jeep Brake switch and ran the wires to the 6 pin connector on the front of the Jeep. I used a quick connector for the ground and placed the Hot in the Center Hole of the 6 pin (was not being used) which is the accessory slot. I then cut the Center Wire on the MH 7 pin connector which is used for Trailer or Toad Backup Lights (was not used in my setup) and ran a single wire in Convoluted Tubing to the front and placed a ¾” Red LED Marker/Clearance on the Dash. I used a short piece of wire and grounded it to a screw under the Dash.
Set it as described in the instruction and went for a Road test. I thought it was breaking the Jeep a little too hard so I let the wife drive the MH and I rode in the Jeep. After a couple times I have it set where I want it. Light breaking it barely applies the brakes. Normal stopping it seems to match the effort the MH is applying. Hard stop it shuts it down in a hurry.
We will be taking a trip soon and that will be the real test.