Curt ManufacturingPart Number:
Class IIReceiver Size:
1.25"Maximum Weight Carrying Capacity:
Gross Trailer Weight: 3500 lbs.
Tongue Weight: 350 lbs.This hitch is sold without a ball mount, pin, or clip. This configuration is ideal if you already have a ball mount, or if you intent to use the hitch for aftermarket accessories like bike racks or cargo carriers instead of for towing.This trailer hitch is designed to fit the following vehicles: 2004-2006 Pontiac GTO
Installation Time: 60 Minutes
--Fits Models: All
--No drilling required
|Curt Trailer Hitches Feature:|
*All trailer hitches come with grade 5 mounting hardware included.
- WeatherTite construction prevents rusting from inside out by sealing the main body of the hitch.
- Durable EverGloss Powder Coat Finish resists rust and corrosion.
- Open back end on receiver for easy cleaning.
- Precision robot welding for superior strength and fit.
- Attractive, seamless, one-piece collar reduces rust and provides improved strength.
Find Curt Trailer Hitches for another vehicle.
Manufacturer: Curt Manufacturing
First off, the hitch mount was much heavier and more solidly built than I expected. It's made out of like 1/2" plate and looks like it could pull down a house. However, there is one problem with this setup. The front mounting is done with the provided M10 capscrews and washers, which replace the capscrews and washers that were in place to hold the shroud to the frame. This went well with no problems. The mounting points on the rear are a bit odd. One side is a M10 stud and the other side is a M12 stud. The length of the M10 stud is too short to allow enough space for the hitch and correct installation of the provided toothed Belleville washer. I had to mount the washer the wrong way to have enough thread engagement on the stud. The problem... Read More
This was a very well designed bolt in part. I am impressed. The instructions give an install time of one hour. I took my time and was done start to finish in just over 30 minutes.