*Special PROMOTION: purchase one set of front tie downs and one set of rear tie downs on the same order and receive 5 percent off your tie down order! Enter the code: TL-TieDown at checkout.
Click below to use our selector and find the parts compatible with your vehicle!
Torklift's Lifetime Tie Down Guarantee
Truck Frame Guarantee
Eliminates bed and bumper damage
Improves camper handling and stability
Does not impact ground clearance
Made in USA!
One pair of tie down brackets (passenger and driver side)
One pair of bracket inserts
Bolt kit and installation instructions
Torklift camper tie down brackets lead industry in strength, quality, advanced design and installation. TorkLift tie downs mount to four independent tie-down points on the frame (with no belly or crossbar). The tie downs work much like your receiver hitch allowing the tie down inserts to be quickly be removed when not in use. When the inserts are removed, the remaining brackets are virtually undetectable.
Each Torklift tie-down bracket is specially designed for each make and model of truck to fit tightly against the frame so as not to compromise ground clearance. By going away from the universal 'one-size-fits-all' approach, Torklift has eliminated problems with correct fit for each particular application. Installation is a breeze.
Manufacturer: Torklift Model: Front Tie Down Bracket Kit - Standard Mount Part Number: C2213 This Torklift camper tie down bracket is designed to fit the following vehicles:
William Kuchera - 10/19/2014 Rating: Two things, I would like to say about this product, first the drivers side tie down should be angled so as not to contact the emergency cable. the second is I put a piece of waxed strings about 4ft long and tied it on the back of the bolt in case it slipped back into the hole. The string gets cut when you tighten the bolt . It helped quite a bit. Otherwise it went on easily. thank you I hope this will help.
Bruce Stenman - 01/28/2012 Rating: The Torklift tie downs for the Chevrolet and GM 2011-2012 trucks are not well designed and pieces have to be cut off the corners to keep the driver's side front tie down and its "spring perch plate" from rubbing though the protective covering for the fuel line and the brake line of the truck.
You will also need to have some thread locker compound like Loc-tite to re-fasten the bolt that comes out of the frame for the bed attachment and is reused to secure the tie downs.
The Bolt Fisher supplied works well but also can break when being removed from the bolt and if that happens you are stopped dead in your tracks. Torklift should put a couple extra of these two cent springs in the kits.
Instructions are not well written but most... Read More
Ronald Collins - 09/21/2011 Rating: Great tie downs. A little hard to get on at first with one person, but two people can do it pretty easy. Strange way to attach but works perfect. Advise to read all instructions and get a firm idea of procedures before you start.
Ronald E Burklund - 06/01/2011 Rating: The instructions for the 2011 GMC are not written correctly. When fishing the bolt through the front spring perch you need to come in from the inside of the frame instead of the bottom which is way too small. Contacted Matt in the service department at the Torklift factory who said he had performed the installation. If he did he could not have used the hole they suggest. He got a hold of someone in engieneering for a fix. I would also suggest that when installing these you start on the pasenger side instead of the driver side as stated because it is much easier to see the correct hole and makes the driver side easier to understand. Good product when finally installed and this is my second set. The ones I ordered for my 2008 GMC were also... Read More