• SAVE UP TO 40%

On All Orders Over $99

live chat

T connector Wiring Harness
[ 55361 ]

List Price: $66.11
Our Price: $38.14
Orders for Curt products over $99 qualify for Free Shipping!
5.0 Star Rating: Recommended  (3 customer reviews)

Manufacturer: Curt Manufacturing
Part Number: 55361

Need trailer wiring? These plug-and-go wiring harnesses are the way to go. They're specifically designed for your vehicle and do not require splicing into your vehicle's wiring. The harness is designed with the wiring, connectors, and circuitry needed to adapt your vehicle's electrical system for trailer compatibility. All wiring harnesses include detailed installation instructions.

This wiring harness is designed to fit the following vehicles:

1997-2003 Infiniti QX4
--Fits Model(s): All
1996-2004 Nissan Pathfinder
--Fits Model(s): All

Installation Instructions
wiring installation instructions

Note: Because we do not have unique pictures of every wiring harness we carry, this wiring harness may vary slighty from the picture above.

Manufacturer: Curt Manufacturing
Part Number: 55361
Current Reviews: 3

Customer Reviews

Alex Forth - 10/08/2010        Rating: 5 of 5 Stars!
This kit designed for Nissan and clips on to the tail light fittings. It's possible to run the wire to the hitch from the driver's side rear interior, through a rubber bush (it won't quite re-seat properly afterward, but that should be ok) that you can't visibly see, but can feel. Locate the bush visually from underneath the car (next to the plastic box on the rear drivers side that's also next to where the hitch attaches to the frame) and thread the wire from the driver's side rear tail light over to where all the wiring is for the rear wiper etc and then drop the wire down to the bush.
Harold Wethington - 09/11/2007        Rating: 5 of 5 Stars!
The wiring harness works as advertised and was shipped promptly. It might be a good idea to make the wires that go to the passenger side a little longer. I had to tuck the converter box inside of the firewall, where if it was a little longer it could have been placed under the floorboard. Also had to remove the tail lights and pull the wire through to get to the plugs for the lights because the square access hole was really too small for my hands to fit through. That is a Nissan problem, but might want to reflect this as an option on the installation instructions. Don't get me wrong, it sure beats splicing/soldering wires!!! Great product and would buy it again in a hearbeat!
David Emmet - 06/05/2007        Rating: 5 of 5 Stars!
Very easy to install in my 2000 Pathfinder. The hardest part was carefully removing the side panels to expose the area where the T connectors went.
Everything fit perfectly and works great.
Write a Review

Related Products and Accessories