• SAVE UP TO 40%

On All Orders Over $99

live chat

T connector Wiring Harness
[ 55310 ]

List Price: $61.81
Our Price: $35.66
Orders for Curt products over $99 qualify for Free Shipping!
5.0 Star Rating: Recommended  (3 customer reviews)

Manufacturer: Curt Manufacturing
Part Number: 55310

Need trailer wiring? These plug-and-go wiring harnesses are the way to go. They're specifically designed for your vehicle and do not require splicing into your vehicle's wiring. The harness is designed with the wiring, connectors, and circuitry needed to adapt your vehicle's electrical system for trailer compatibility. All wiring harnesses include detailed installation instructions.

This wiring harness is designed to fit the following vehicles:

2009-2012 Hyundai Elantra
--Fits Model(s): Wagon
--3 wire system, converter included
2001-2006 Hyundai Santa Fe
--Fits Model(s): All
--3 wire system, converter included
2011 Kia Rio5
--Fits Model(s): All
--3 wire system, converter included

Installation Instructions
wiring installation instructions

Note: Because we do not have unique pictures of every wiring harness we carry, this wiring harness may vary slighty from the picture above.

Manufacturer: Curt Manufacturing
Part Number: 55310
Current Reviews: 3

Customer Reviews

Patrick Carney - 08/01/2011        Rating: 5 of 5 Stars!
Everything fits and works perfectly. Took about thirty minutes from start to finish. The instructions didn't mention this, but I found the job went much easier after I loosened the top piece of trim (the little shelf-like piece under the side window).
Charles Weber - 05/04/2011        Rating: 5 of 5 Stars!
Great wiring harness. Plugged in without issue. I would recommend before installing this to order some matching push fasteners for the trim panels. I did break a couple of them even while using the correct panel pulling tools. Would also recommened purchasing a tube of dielectric grease for the connectors. This will assure a good connection at the plugs. I ran my flat connector through the rubber drain grommet in the bottom of the spare tire wheel housing to the outside of the vehicle and then attached it to the hitch. I've never had any complaint with Curt products.
Douglas Szymuszkiewicz - 09/26/2010        Rating: 5 of 5 Stars!
Unit plugs right in, no cutting wires. Prep work getting side panels loose is the longest part of it.
Write a Review

Related Products and Accessories